Users Guide

3. Click Apply.

Configuring Events And Alarms

The Dell Management Center Events and Alarms page enables or disables all hardware alarms. The current alert status is displayed on the

vCenter Alarms tab. A critical event indicates actual or imminent data loss or system malfunction. A warning event is not necessarily

significant, but may indicate a possible future problem. Events and alarms can also be enabled using the VMware Alarm Manager. Events

are displayed on the vCenter Tasks and Events tab in the Hosts and Clusters view. In order to receive the events from the servers,

OMIVV will be configured as the SNMP trap destination. For 12th generation hosts and later, the SNMP trap destination will be set in

iDRAC. For hosts prior to 12th generation, trap generation will be set in OMSA. You can configure events and alarms using the

OpenManage Integration for VMware vCenter from Management > Settings tab. Under vCenter Settings, expand the Events and

Alarms heading to display the current vCenter Alarms for Dell Hosts (Enabled or Disabled), or for all and the Event Posting Level.

NOTE: OMIVV supports SNMP v1 and v2 alerts for 12th generation hosts and later. For hosts prior to 12th generation,

OMIVV supports SNMP v1 alerts in vCenter. For more information on setting trap destination, see Setting Up An OMSA

Trap Destination.

NOTE: To receive Dell events, you must enable both alarms and events.

1. To the right side of Events and Alarms, click the Edit icon.

2. To enable all hardware alarms and events, select the Enable Alarms for all Dell Hosts check box.

NOTE: Dell hosts that have alarms enabled respond to critical events by entering maintenance mode and you can

modify the alarm as needed.

3. To restore the default vCenter alarm settings for all managed Dell servers, click Restore Default Alarms.

It may take up to a minute before the change takes effect.

NOTE: This step is only seen if Enable Alarms For Dell Hosts is selected.

4. Under Event Posting Level, select one of the following:

• Do not post any events

This options blocks hardware events.

• Post All Events

This option posts all hardware events.

• Post only Critical and Warning Events

This option posts only critical or warning level hardware events.

• Post only Virtualization-Related Critical and Warning Events

This option posts only virtualization-related critical and warning events. This is the default event posting level.

5. If you want to apply these settings to all vCenters, select the Apply these settings to all vCenters check box.

NOTE: Selecting this option overrides the existing settings for all vCenters.

This option is grayed out if you already selected All Registered vCenters from the drop-down list on the Setting page.

6. To save, click Apply.

Viewing the Alarm and Event Settings

Once alarms and events are configured you can view if the vCenter alarms for hosts are enabled and which event posting level is selected

on the Settings tab.

1. In the OpenManage Integration for VMware vCenter > Manage > Settings tab, under vCenter Settings, expand Events and

Alarms.

2. Under Events and Alarms you can view the following:

• vCenter Alarms for Dell Hosts: Displays either Enabled or Disabled.

• Event Posting Level

To see the event posting levels that can display, see Understanding Alarms and Events.

3. To configure alarms and events, see Configuring Events and Alarms

Settings