Users Guide

To x a server in a disabled state:
1. Open the Chassis Management Controller console and select the disabled server.
2. To automatically open the iDRAC console, click Launch iDRAC GUI.
3. Navigate to the user list in iDRAC console, and choose one of the following:
• iDRAC 6 : Select iDRAC settings → Network/Security tab → Users tab.
•
iDRAC 7 : Select iDRAC settings → Users tab.
• iDRAC 8 : Select iDRAC settings → Users tab.
4. To edit the settings, in the User ID column, click the link for the admin (root) user.
5. Click Congure User, and then click Next.
6. In the User Conguration page for the selected user, select the check box next to Enable user, and then and click Apply.
Does the OpenManage Integration for VMware vCenter support the VMware vCenter Server
appliance?
Yes, the OpenManage Integration for VMware vCenter supports the VMware vCenter Server appliance since v2.1.
Does the OpenManage Integration for VMware vCenter support the vSphere Web Client?
Yes, the OpenManage Integration for VMware vCenter supports the VMware vSphere Web client.
Why is my rmware level still not updated when I have performed rmware update with Apply
on Next reboot option and the system was rebooted?
To update rmware, run the inventory on the host after the reboot is completed. In some cases, where the reboot event does not
reach the appliance, the inventory is not automatically triggered. In such situation, you must rerun the inventory manually to get the
updated rmware versions.
Why is the host still shown under the chassis even after removing the host from the vCenter
tree?
The hosts under the chassis are identied as part of the chassis inventory. After a successful chassis inventory, the host list under
the chassis is updated. Therefore, even if the host is removed from the vCenter tree, the host still shows under the chassis till the
next chassis inventory is run.
In the Administration Console, why the Update Repository Path is not set to default path after I
reset the appliance to factory settings?
After you reset the appliance, go to the Administration Console, and then click APPLIANCE MANAGEMENT in the left pane. In the
Appliance Settings page, the Update Repository Path is not changed to default path.
Resolution: In the Administration Console, manually copy the path in the Default Update Repository eld to Update Repository
Path eld.
After backup and restore of OpenManage Integration for VMware vCenter, why alarm settings
are not restored?
Restoring the OpenManage Integration for VMware vCenter appliance backup does not restore all the Alarm settings. However, in
the OpenManage Integration for VMware GUI, the Alarms and Events eld displays the restored settings.
Resolution: In the OpenManage Integration for VMware GUI, in the Manage → Settings tab, manually change the Events and
Alarms settings.
125