Manualshelf

Users Guide

ManualsBrandsDell ManualsActive System ManagerOpenManage Integration for Microsoft System Center Operations Manager (SCOM) Version 7.3
81828384858687888990
Table Of Contents
9. Delete the Dell Management pack folder that is present in local drive by following the path: %PROGRAMFILES%\Dell
Management Packs\Server Mgmt Suite\<version>\
10. Delete the Dell Server Management Pack Suites Registry entry from the Registry Editor by doing the following:
a. Select HKEY_LOCAL_MACHINE > SOFTWARE > Dell.
b. Right-click Dell Server Management Pack Suites and delete the registry entry.
After the de-enrollment job completes, manually revert the
prerequisites configured by the OMIMSSC appliance version 7.2
After the de-enrollment job completes in the OMIMSSC appliance version 7.3, prerequisites that are configured on the SCOM
Management Servers by the OMIMSSC appliance version 7.2 are not reverted.
Workaround: Manually revert the following configurations on the SCOM Management Servers:
● SSL listener
● Basic Auth Support
● Firewall rule to allow WinRM HTTPS
● PS Remoting
● WinRM Client Authentication
● WinRM Service Authentication
● WinRM AllowUnencrypted service
Discovery and monitoring Dell EMC devices-related
issues
Unable to discover and monitor devices after restarting OMIMSSC
About this task
When OMIMSSC restarts, the connectivity between the SCOM console and the OMIMSSC appliance is lost. After the appliance
is started, all the discovery and monitoring features of the Dell EMC devices is restored during the next discovery and
monitoring cycle respectively.
NOTE: The default discovery and the monitoring cycle is 24 hours.
If you want to start the discovery and monitoring of the Dell EMC device before the 24 hours cycle, you can change the
override values.
To change the override values, do the following:
Steps
1. Log in to OMIMSSC.
2. Select Profiles and Configuration > Configuration.
3. Click the Edit tab, and then select the device to edit the override value.
4. In the discovery interval column, edit the override value, and then click Apply.
The discovery is triggered again immediately after changing the override values.
(Optional) You can view the applied changes by selecting Jobs and Logs Center > Scheduled jobs.
A job run on OMIMSSC to discover a device stays in the Progress
state for more than five hours
The device discovery job that is run from OMIMSSC gets stuck in the running task list for more than five hours.
Workaround—Create and run a new job for the device discovery with same set of IP addresses.
86
Troubleshooting