Users Guide

i. In the Summary section, confirm the data that you have provided, and then click Finish.
2. Set the number of virtual processors count value to 4, because by default, the processor count is set to 1. To set the
processor count:
a. In the list of VMs, right-click OMIMSSC, and then select Settings.
b. In the Settings dialog box, in the left pane, select Processor.
c. In the Number of virtual processors box, enter or select 4.
d. Click OK.
3. To enable the Time synchronization option on the VM hosted on Hyper-V, do the following:
a. Select the VM hosted on Hyper-V.
b. Right-click the VM and select Settings.
c. Click Management > Integration Services > Time Synchronization.
The Hyper-V and SCOM Management Server times are synced.
Ensure that OMIMSSC appliance is hosted on Hyper-V
About this task
After deploying OMIMSSC on Hyper-V, to ensure that the OMIMSSC is hosted on the Hyper-V with the required configurations,
do the following:
Steps
1. Right-click the OMIMSSC appliance VM and click Settings.
2. Ensure that the memory space and processor count are as recommended.
a. Else, assign the memory in Startup RAM and click Apply.
3. Ensure that the processor count is as recommended.
a. Else, specify the number of processors counts in Number of Virtual processors count under Processors.
4. Click IDE Controller:IDE Controller 0 > Hard Drive, and then ensure that the Virtual hard disk field is indicating to the
OMIMSSC file.
a. Else, click Browse, and select the OMIMSSC extracted file.
b. Click Apply.
5. Ensure that the virtual switch is connected to a physical NIC.
a. Else, configure the NIC, and select the appropriate NIC from the Virtual Switch drop-down menu.
b. Click Apply.
6. From the Hyper-V Manager menu, right-click the appliance VM and perform the following tasks:
a. Click Connect, and then click Start.
If the newly created VM with the selected VD of appliance fails to boot with any kernel panic exception, edit the VM
settings. And, then enable the dynamic memory option for the VM.
Deploy and configure OMIMSSC on ESXi
About this task
Before deploying OMIMSSC by using ESXi, ensure that you extract the OVA file from the compressed ZIP file to a local drive. To
deploy OMIMSSC on ESXi, do the following:
Steps
1. Start ESXi by using the IP address.
The VMware ESXI login page is displayed.
2. Enter the username and password, and then click Log in.
3. In the left pane, select Virtual Machines.
4. To create a VM, select Create / Register VM.
The New virtual machine wizard is displayed.
a. In the Select creation type section, select Deploy a virtual machine from an OVF or OVA file.
22
Deploy and configure the OMIMSSC appliance for SCOM