Manualshelf

Users Guide

ManualsBrandsDell ManualsActive System ManagerOpenManage Integration for Microsoft System Center Operations Manager (SCOM) Version 7.3
101102103104105106107108109110
Table Of Contents
3. Select the monitoring feature that you want to remove.
4. Under the Tasks pane, expand Dell EMC Monitoring Feature Tasks.
5. To remove the monitoring feature, click Remove Feature.
For example, to remove Dell EMC Servers and Rack Workstations Monitoring feature, click Remove Monitoring
Feature in the Tasks pane.
6. On the Run Task—Remove Feature screen, click Use the predefined Run As Account.
7. Click Run.
CAUTION: If there are any dependencies or associations that have to be overridden, which result in data loss,
the task cannot be successfully run. To continue to run the task, click Override, and set the AutoResolve
Warnings/ Errors override to True.
8. After the task is complete, click Close.
Results
NOTE: Running the Remove Monitoring Feature task in Dell EMC Feature Management Dashboard may fail if there
are overrides that are referenced to custom group or instances. In such a case, ensure to remove the overrides that are
associated to custom group or instances.
Severity levels of discovered devices
The symbols that indicate the severity levels of the discovered Dell EMC devices on the SCOM console:
● —Normal/OK—The component is working as expected.
● —Critical/Failure/Error—The component has either failed or a failure is imminent. The component requires immediate
attention and may must be replaced. Data loss may have occurred.
● —Warning/Noncritical—A probe or other monitoring device has detected a reading for the component that is greater
than or lesser than the acceptable level. The component may still be functioning, but it could fail. The component may also
be functioning in an impaired state.
●
—The health status is not applicable for the specific component.
● —The service is unavailable.
Run tasks on the SCOM console
Steps
1. In the left pane of SCOM, select Monitoring.
2. Expand Dell EMC.
3. Expand either Diagram Views, State Views, or Alerts Views.
4. Select the device on which you want to run the task.
A list of tasks you can run by using the monitoring feature that is used by the device is displayed in the Tasks pane of the
SCOM console.
5. In the Tasks pane, click the task that you want to run.
The task is started, and after the task is successfully run, a summary of the task is displayed.
102
Reference topics