Release Notes

To workaround this issue, do not select the group node for discovery, but rather just the devices within

that group.

Issue 3:

Description: An EqualLogic storage array is displayed even after excluding the EqualLogic discovery

range.

Resolution: If the EqualLogic Group Management, EqualLogic Storage Group, and all the EqualLogic

member IP addresses are included in a single discovery range configuration, excluding that range will

exclude the entire group in the device tree.

If these IP addresses are distributed among multiple discovery range configurations, to exclude the

EqualLogic group, all the associated discovery ranges must be excluded.

Issue 4:

Description: For Dell PowerVault MD storage arrays with thin virtual disks, the Virtual Disk Information

table in the OpenManage Essentials device inventory displays the name of the repository for thin

provisioning instead of the thin virtual disk name. [42606]

Issue 5:

Description: For Dell PowerVault MD storage arrays, OpenManage Essentials displays critical health

status, even if the device is in a warning state. [42607]

Issue 6:

Description: The model number for both Dell Force10/Networking C150 and C7004 Ethernet switches is

displayed as C150/C7004 switch in the device inventory. The model number for both Dell Force10/

Networking C300 and C7008 Ethernet switches is displayed as C300/C7008 switch in the device

inventory. [43443]

Issue 7:

Description: vFlash information is displayed in the iDRAC Information table in the device inventory even

though this information does not belong to the iDRAC information section. [41115]

Issue 8:

Description: The Service Tag may not be displayed correctly in the device inventory for certain

PowerVault MD Series storage arrays. [40631]

Issue 9:

Description: OEM devices discovered using the SNMP or WS-Man protocol are classified under Modular

Systems in the device tree. [40572]

Issue 10:

Description: When a PowerEdge FX2s chassis is discovered using WS-Man protocol, the hostname of the

corresponding mapped sled is not displayed in the PCIe Slot Information table in the device inventory.

[37351]