Release Notes

Issue 3:
Description
An EqualLogic storage array is displayed even after excluding the EqualLogic discovery range.
Resolution
If the EqualLogic Group Management, EqualLogic Storage Group, and all the EqualLogic member IP
addresses are included in a single discovery range configuration, excluding that range will exclude the
entire group in the device tree.
If these IP addresses are distributed among multiple discovery range configurations, to exclude the
EqualLogic group, all the associated discovery ranges must be excluded.
Issue 4:
Description
For Dell PowerVault MD storage arrays with thin virtual disks, the Virtual Disk Information table in the
OpenManage Essentials device inventory displays the name of the repository for thin provisioning
instead of the thin virtual disk name. [42606]
Issue 5:
Description
For Dell PowerVault MD storage arrays, OpenManage Essentials displays critical health status, even if the
device is in a warning state. [42607]
Issue 6:
Description
The model number for both Dell Force10/Networking C150 and C7004 Ethernet switches is displayed as
C150/C7004 switch in the device inventory.The model number for both Dell Force10/Networking C300
and C7008 Ethernet switches is displayed as C300/C7008 switch in the device inventory. [43443]
Issue 7:
Description
vFlash information is displayed in the iDRAC Information table in the device inventory even though this
information does not belong to the iDRAC information section. [41115]
Issue 8:
Description
The Service Tag may not be displayed correctly in the device inventory for certain PowerVault MD Series
storage arrays. [40631]
Issue 9:
Description
OEM devices discovered using the SNMP or WS-Man protocol are classified under Modular Systems in
the device tree. [40572]
Issue 10:
Description
When a PowerEdge FX2s chassis is discovered using WS-Man protocol, the host name of the
corresponding mapped sled is not displayed in the PCIe Slot Information table in the device
inventory. [37351]
Issue 11:
Description
When a PowerEdge FM120x4 sled is discovered in-band using SSH protocol, the Embedded Device
Information table is not displayed in the device inventory. [39312]