Owner's Manual


Issue 28:
Description
To Install OpenManage Server Administrator on a 64-bit Linux system, install the following 32-bit rpms
and their dependent packages before running OpenManage Server Administrator Deploy task from
OpenManage Essentials:
 compat-libstdc++-33.i686
 libxml2.i686
 pam.i686
 glibc.i686
 zlib.i686
 libgcc.i686
Issue 29:
Description
While creating an OpenManage Server Administrator update deployment task; the task may remain in
“In-progress” state for 6 hours. This occurs in certain scenarios where OpenManage Server Administrator
was not properly uninstalled prior to running the update deployment task. This may also occur if the task
was interrupted during the deployment process.
Resolution:
Before running the update deployment task, make sure that OpenManage Server Administrator is
uninstalled from the target server and then create the OpenManage Server Administrator deployment
task.
Issue 30:
Description
Creating a Remote Server command task with the command “omreport system alertlog” may take longer
than expected to complete. The task may fail to complete if the alert logged on the target system is
unusually large.
Resolution:
Review the alert log on the system to determine if the log can be cleared.
Issue 31:
Description
When the Server Administrator deployment task is performed on more than 20 Linux targets, the task
may fail. This issue is due to the limitation on the number of simultaneous Server Administrator
deployments task OpenManage Essentials is capable of.
Resolution:
It is recommended to deploy Server Administrator on up to 20 targets for each task.
Issue 32:
Description
When creating a Command Line task and selecting Remote Server Administrator command for a Linux
target using a command other than omreport and omconfig, the task status indicates the task as
completed and displays a green status . This occurs because the Remote Server Administrator command
supports omreport and omconfig commands.
Resolution:
While creating a Remote Server Administrator command, make sure to use only omreport and omconfig
commands for the task to return correct data. You can get the complete list of these commands at
support.dell.com.