CLI Guide

• powerdown—performs server power off.
• powerup—performs server power-on.
• powercycle—performs server power cycle.
• hardreset—force hard server power reset.
• graceshutdown—perform graceful shutdown of server.
• reseat—perform a virtual reseat of a server or storage.
NOTE: This action requires -f option to force the action.
NOTE: reseat is the only action which can be performed for the storage devices.
• powerstatus—display current power status of server.
NOTE: This action is not allowed with -a option.
Synopsis
racadm serveraction -m <module> <action>
racadm serveraction -a <action>
Input
• -m—The <module> must be server-<n>, where n = 1 to 8
• -a—Performs power action on all servers
Example
• Power action on a single server:
racadm serveraction -m server-1 powerdown
• Power action on all servers:
racadm serveraction -a powerup
• Reseat action on a single storage:
racadm serveraction -m storage-2 -f reseat
setniccfg
Description
Modifies network configuration properties.
Synopsis
racadm setniccfg [-m <module>] -d
racadm setniccfg [-m <module>] -d [-6]
racadm setniccfg [-m <module>] -s <ipAddress> <netmask> <gateway>
racadm setniccfg [-m <module>] -s -6 <ipv6Address> <prefixlen> <gateway>
racadm setniccfg [-m <module>] -v [vlan_id]
Input
• -m—The <module> option must be one of the following values:
○ switch-<n>, where n = 1-6
○ chassis—The default state if -m is not specified.
• -d—Enables DHCP for the Ethernet management port.
• -s—Enables static IP address, netmask, and gateway settings.
NOTE:
○ Enter the IP address, netmask, and gateway as dotted decimal strings.
RACADM sub command details 23