Users Guide
Table Of Contents
- Dell EMC OpenManage Enterprise-Modular Edition Version 1.00.01 for PowerEdge MX7000 Chassis User's Guide
- Overview
- Updating the management module firmware
- Logging in to OME-Modular
- Logging in to OME–Modular as local, Active Directory, or LDAP user
- OME-Modular home page
- Viewing device health
- Setting up chassis
- Initial configuration
- Configuring chassis settings
- Managing chassis
- Chassis groups
- Controlling chassis power
- Backing up chassis
- Restoring chassis
- Exporting chassis profiles
- Managing chassis failover
- Troubleshooting in chassis
- Blinking LEDs
- Interfaces to access OME-Modular
- Viewing chassis hardware
- Viewing chassis alerts
- Viewing chassis hardware logs
- Configuring OME–Modular
- Managing compute sleds
- Managing Storage
- Managing templates
- Managing identity pools
- Ethernet IO Modules
- MX scalable fabric architecture
- SmartFabric Services
- Managing networks
- Managing Fibre Channel IOMs
- Managing firmware
- Monitoring alerts and logs
- Monitoring audit logs
- Troubleshooting
- Storage
- Firmware update is failing
- Storage assignment is failing
- IOM status is downgraded
- IOM health is downgraded
- Drives on compute sled are not visible
- Storage configuration cannot be applied to IOMs
- Drives in OpenManage are not visible
- iDRAC and OpenManage drive information do not match
- The assignment mode of storage sled is unknown
- Storage
- Recommended slot configurations for IOMs
4. Click Add Network.
The Define Network window is displayed.
5. Enter Name, Description, VLAN ID and select the Network Type.
For the network types, see the Online Help.
Editing uplink
To edit an existing uplink:
1. From the Devices drop-down, select Fabric.
The Fabric page is displayed.
2. From the fabrics table, select the fabric and click View Details.
The Fabric Details page is displayed.
3. From the Uplinks table, select the uplink and click Edit.
The Edit uplink page is displayed.
4. Edit theName, Description, and Uplink Type fields as necessary, and then click Next.
5. Select the necessary Switch Ports and select any Tagged Networks or Untagged Networks.
To configure new network other than the existing ones, click Add Network and enter the network details. For more details
see, Adding Network.
NOTE: You cannot edit the ports or networks when uplinks are in FCoE, FC Gateway, or FC Direct Attach modes.
Viewing topology details
To view topology details:
● From the Devices drop down, select Fabric.
● From the fabrics table, select the fabric and click View Details.
● From the Fabric Details page, click Topology.
The topology of the fabric is displayed.
Editing fabric details
To edit the fabric details:
1. From the Devices drop down, select Fabric.
The Fabric page is displayed.
2. From the fabrics table, select the fabric and click Edit.
The Edit Fabric page is displayed.
3. Make the necessary changes to the Name and Description fields.
Deleting uplinks
To delete an uplink:
1. From the Devices drop down, select Fabric.
The Fabric page is displayed.
2. In the fabrics table, select any fabric and click View Details.
3. In the uplinks table, select the uplink to be deleted.
4. Click Delete. Click Yes to confirm the deletion.
Deleting fabric
To delete an existing fabric:
1. From the Devices drop-down, select Fabric.
64
SmartFabric Services