Users Guide
Table Of Contents
- Dell EMC OpenManage Enterprise-Modular Edition Version 1.00.10 for PowerEdge MX7000 Chassis User's Guide
- Overview
- Updating the management module firmware
- Logging in to OME-Modular
- Logging in to OME–Modular as local, Active Directory, or LDAP user
- OME-Modular home page
- Viewing device health
- Setting up chassis
- Initial configuration
- Configuring chassis settings
- Managing chassis
- Chassis groups
- Controlling chassis power
- Backing up chassis
- Restoring chassis
- Exporting chassis profiles
- Managing chassis failover
- Troubleshooting in chassis
- Blinking LEDs
- Interfaces to access OME-Modular
- Viewing chassis hardware
- Viewing chassis alerts
- Viewing chassis hardware logs
- Configuring OME–Modular
- Managing compute sleds
- Managing Storage
- Managing templates
- Managing identity pools
- Ethernet IO Modules
- MX scalable fabric architecture
- SmartFabric Services
- Managing networks
- Managing Fibre Channel IOMs
- Managing firmware
- Monitoring alerts and logs
- Monitoring audit logs
- Troubleshooting
- Storage
- Firmware update is failing
- Storage assignment is failing
- SAS IOM status is downgraded
- SAS IOM health is downgraded
- Drives on compute sled are not visible
- Storage configuration cannot be applied to SAS IOMs
- Drives in OpenManage are not visible
- iDRAC and OpenManage drive information do not match
- The assignment mode of storage sled is unknown
- Storage
- Recommended slot configurations for IOMs
Configuring admin status
You can switch the admin status for all ports, which is enabled by default. For the MX9116n FSE port groups 1/1/15 and 1/1/16,
when you breakout the fiber channel ports, the admin status is disabled by default. Enable the status if required.
To switch the admin status:
Select the port and click Toggle Admin State.
The Toggle Admin State window is displayed.
Configuring Maximum Transmission Unit
You can configure the Maximum Transmission Unit (MTU) for full-switch and fabric mode IOMs. The MTU can be configured for
the Ethernet ports 1/1/1 to 1/1/16.
To configure MTU:
1. Click Devices > I/O Modules > View Details > Hardware > Port Information.
2. Select the Ethernet port and click MTU.
The Configure MTU window is displayed.
3. Select the MTU Size.
The approximate value for MTU is 1500 bytes. The default value is 1532 bytes, and the maximum is 9000 bytes. If the port
has both FCoE and Ethernet, the value is 2500 bytes.
Configuring auto negotiation
You can switch auto negotiation (AutoNeg). For DAC cabling, the AutoNeg is enabled by default. For AOC (fiber), the AutoNeg
is disabled by default.
To switch the AutoNeg:
Select the port and click Toggle AutoNeg.
The Toggle AutoNeg window is displayed.
If Ethernet links are not displayed automatically, switch the auto negotiation setting.
54
Ethernet IO Modules