Users Guide

Setting up chassis
When you log in to the OME–Modular web interface for the first time, the configuration wizard is displayed. If you close the
wizard, you can access it again by clicking Configure > Initial Configuration. This option is displayed only if the chassis is not
yet configured.
To configure the chassis:
1. Log into OME–Modular.
The Home page is displayed.
2. Click Configure > Initial Configuration.
The Chassis Deployment Wizard is displayed.
For further steps, see Initial configuration.
Initial configuration
Dell EMC recommends the following configuration threshold for better performance of the chassis. If the configuration exceeds
the threshold, then some features including firmware update, backup, and restore may not work as expected. It may also affect
system performance.
Component
Count
Templates 320
Alert Policy 50
Identity pool 501
Network (VLAN) 214
Catalog 50
Baseline 50
To configure a chassis:
1. Click Devices > Chassis > View Details > Configure > Initial Configuration.
The Chassis Deployment Wizard is displayed.
NOTE: You can configure the chassis using an existing chassis profile.
2. In the Import Profile tab, click Import to open the Import Profile window.
Enter details of the network share, where the chassis profile is located and click Import.
3. In the Time Configuration tab, select the Configure Time Settings to configure the time zone and timestamp of the
configuration.
4. Select the Use NTP check box to configure the primary, secondary, or tertiary NTP addresses and click Next.
NOTE:
It is recommended that at least three valid NTP servers, which synchronize to a single time source, are used to
ensure reliable synchronization.
If you select multiple NTP servers, OME–Modular selects the NTP server algorithmically.
The Activity and Alerts tab is displayed.
5. Configure the email, SNMP, and system log settings and click Next.
The iDRAC tab is displayed.
6. Select the Configure iDRAC Quick Deploy Settings check box to configure the password to access the iDRAC web
interface and the management IP, and click Next.
You can select the slots to which the iDRAC Quick Deploy settings must be applied.
The Network IOM tab is displayed.
7. Select the Configure I/O Module Quick Deploy Settings check box to configure the password to access the IOM console
and management IPs, and click Next.
The Firmware tab is displayed.
8. Select the Configure all devices to use following catalog check box, select the network share type and, click Catalog to
open the Add Firmware Catalog window.
Logging in to OME-Modular
35