Users Guide

To update the firmware using the catalog-based compliance method:
1. Update the device adapter operating system drivers followed by the device adapter firmware.
NOTE: For device adapter firmware versions, see, the respective user's guide and release notes.
2. Go to the Configuration Firmware page to create the catalog and baseline using Validated Stack catalog.
3. Select the baseline and click View Report. Compliance Report page is displayed.
4. Update the devices in the following sequential order.
a. Compute
i. From the Advance Filters, select Compute from the Type. The list of Compute devices is displayed.
ii. Click Select all checkbox and then click Make Compliant.
iii. Go to the Monitor > Jobs page to view the job status.
iv. Wait for the Compute updates to complete and then start the Chassis update.
b. Chassis
i. From the Advance Filters, select Chassis from the Type and enter OpenManage Enterprise Modular in the
Component Contains box.
ii. Click Select all checkbox and then click Make Compliant.
iii. Go to the Monitor > Jobs page to view the job status.
iv. Wait for the Chassis updates to complete and then start the Network IOM update.
c. Network IOM
i. From the Advance Filters, select Network IOM from the Device Type. The list of Network IOM devices is
displayed.
ii. Select the required number of IOMs and click Make Compliant.
NOTE: See the IOM Firmware update matrix and Grouping IOMs for firmware update from updating Firmware
section to view the combination of IOMs that can be updated.
iii. Go to the Monitor > Jobs page to view the job status.
iv. Wait for the Network IOM updates to complete and then start the ONIE component update.
d. ONIE Component
i. Select the baseline and click View Report. Compliance Report page is displayed. After performing all the updates,
you can view only the list of ONIE component for update.
NOTE: ONIE component are listed only when all the IOMs are updated to 1.30.00 baseline.
ii. Click Select all checkbox and then click Make Compliant.
iii. Go to the Monitor > Jobs page to view the job status.
OME-M firmware update matrix
Table 3. OME-M firmware update matrix
To
OME-M
1.00.01
OME-M
1.00.10
OME-M
1.10.00
OME-M
1.10.10
OME-M
1.10.20
OME-M
1.20.00
OME-M
1.20.10
OME-M
1.30.00
From
OME-M
1.00.01
Yes Yes
OME-M
1.00.10
Yes Yes Yes
OME-M
1.10.00
Yes Yes Yes Yes Yes Yes
OME-M
1.10.10
Yes Yes Yes Yes Yes
OME-M
1.10.20
Yes Yes Yes Yes
OME-M
1.20.00
Yes Yes Yes
OME-M
1.20.10
Yes Yes
18 Updating firmware for PowerEdge MX solution