CLI Guide
Table Of Contents
- Dell EMC OpenManage Enterprise Modular Edition for PowerEdge MX7000 Chassis RACADM Command Line Reference Guide
- Contents
- Introduction
- RACADM sub command details
- Guidelines to quote strings containing special characters when using RACADM commands
- Question mark and question mark with subcommand
- help and help with subcommand
- arp
- chassisaction
- chassisgroup
- chassislog
- cmcchangeover
- config
- connect
- deploy
- faultlist
- getconfig
- getmodinfo
- getniccfg
- getpbinfo
- getpminfo
- getsensorinfo
- getsysinfo
- ifconfig
- ping
- ping6
- racreset
- racresetcfg
- serveraction
- setniccfg
- swinventory
- traceroute
- traceroute6
- OpenManage Enterprise Modular property database group and object descriptions
● -m—The <module> option must be one of the following values:
○ server-<n>—where n = 1-8
○ switch-<n>—where n = 1-6
CAUTION: When run from the OME–Modular serial console, the connect -b option stays
connected until the management module resets or the serial console is terminated. This
connection is a potential security risk.
NOTE: The racadm connect to server prompts you to enter the iDRAC credentials for connecting
to the server.
Example
● Connect to server 1 serial console:
racadm connect -m server-1
● Connect to I/O module 1 serial console:
racadm connect -m switch-1
NOTE: When you run the racadm connect -m switch-<N> command for the first time, the
option to enter the user credentials is not displayed. Press Enter again to view the option to enter
the user credentials.
NOTE: Use quit key that is configured on the iDRAC to quit the console.
NOTE: When you run the command, racadm connect -m switch-<N>, the first time, the option to enter the user
credentials is not displayed. Press [Enter] again to view the option to enter the user credentials.
deploy
Description
Deploys blade or IOM by specifying required properties.
In the firmware or SSH racadm interface, enter a backward slash before the string. For example:
xyz\^123. In remote racadm, enter the string in double quotes. For example: "xyz^123".
NOTE: The quick deploy command is not supported in RACADM.
Synopsis
racadm deploy -m server-<n> -u root -p <password> -s <ipaddress>
<subnet> <gateway>
racadm deploy -m server-<n> -u root -p <password> -s -6 <ipv6Address>
<prefixlen> <gateway>
racadm deploy -m server-<n> -u root -p <password> -d [-6]
racadm deploy -m switch-<n> -u root -p <password>
racadm deploy -m switch-<n> -v SNMPv2 <snmpCommunityString> ro
racadm deploy -a [server|switch] -u root -p <password>
NOTE: For IOMs, you can only configure SNMPv2 community strings.
Input
● -m—<module>—must be one of the following values:
○ server
○ switch
16 RACADM sub command details