Users Guide

The IPv6 Address, Prefix Length, and Gateway options are enabled only if the Enable Autoconfiguration check box is

cleared.

7. In the DNS Server Settings section, enter the Preferred DNS Server, Alternate DNS Server 1, and Alternate DNS

Server 2 addresses.

For MXG610s IOMs, you can set the Preferred DNS and Alternate Server 1 and 2 addresses. However, the server address for

Alternate DNS Server 2 is not applied though the response is successful as, MXG610s IOMs support only two server

address for DNS settings.

8. In the Management VLAN section, select Enable VLAN and enter the VLAN ID.

Configuring root password

To configure the root password:

1. Click All Devices > I/O Modules > View Details > Settings > Management or Devices > I/O Modules > View Details >

Settings > Management.

The I/O Modules page is displayed.

2. Enter the Host Name and Root Password for the IOM.

Configuring SNMP settings

To configure the SNMP settings:

1. Click All Devices > I/O Modules > View Details > Settings > Monitoring or Devices > I/O Modules > View Details >

Settings > Monitoring.

2. Select Enable SNMP to configure the SNMP version and community string.

Configuring advanced settings

To configure the advanced IOM settings:

1. Click All Devices > I/O Modules > View Details > Settings > Advanced or Devices > I/O Modules > View Details >

Settings > Advanced.

2. Select the options to replicate the chassis time and alert settings to the IOM.

Configuring ports

You can configure breakout, admin status, and MTUs for IOMs. You can configure breakout only for port groups.

NOTE: The port description is applicable only to full-switch mode IOMs. Update the port description in the IOM CLI.

To configure breakout:

1. Click Devices > I/O Modules > View Details > Hardware > Port Information.

2. Select the port group and click Configure Breakout.

The Configure Breakout window is displayed.

3. Select the Breakout Type.

First apply "Hardware Default" and then select the required breakout.

NOTE: Breakouts can be configured only for Fabric Mode IOMs.

Configuring admin status

You can toggle admin status for all ports is enabled by default. For the MX9116n FSE port groups 1/1/15 and 1/1/16, when you

breakout the fibre channel ports, the admin status is disabled by default. Enable the status if required.

To toggle the admin status:

Select the port and click Toggle Admin State.

Ethernet IO Modules