CLI Guide

● Display chassis network settings
racadm getniccfg -m chassis
getpbinfo
Description Gets power budget status information. If there is no power supply to the PSU, the output of the
command is displayed as "failed". If there is a mismatch in the power source, for example, a PSU of 220
volts and PSU of 110 volts are combined, then the output of the command is displayed as "Configuration
Error".
Synopsis
racadm getpbinfo
Input
racadm getpbinfo
Example
racadm getpbinfo
[Power Budget Status]
System Input Power = 615 W (2098 BTU/h)
Peak System Power = 628 W (2142 BTU/h)
Peak System Power Timestamp = 11:37:36 08/08/2018
Minimum System Power = 606 W (2067 BTU/h)
Minimum System Power Timestamp = 10:16:08 08/06/2018
Overall Power Health = Not OK
Redundancy = No
System Input Power Cap = Disabled
Redundancy Policy = None
Dynamic PSU Engagement Enabled = Not Applicable
System Input Max Power Capacity = 11571 W
Input Redundancy Reserve = Not Applicable
Input Power Allocated to Servers = Not Applicable
Input Power Allocated to Chassis Infrastructure = Not Applicable
Total Input Power Available for Allocation = 2385 W (8137 BTU/h)
Standby Input Power Capacity = Not Applicable
Server Based Power Management Mode = Not Applicable
Max Power Conservation Mode = Not Applicable
Server Performance Over Power Redundancy = Not Applicable
Power Available for Server Power-on = Not Applicable
Extended Power Performance(EPP) Status = Not Applicable
Available Power in EPP Pool = Not Applicable
Used Power in EPP Pool = Not Applicable
EPP Percent - Available = Not Applicable
[Chassis Power Supply Status Table]
<Name> <Model> <Power State>
<Input Current> <In
put Volts> <Output Rated Power>
PS1 PSU.Slot.1 Failed (No Input
Power) 0 A 0 V
3000 W
PS2 PSU.Slot.2 Absent
N/A N/A
N/A
PS3 PSU.Slot.3 Absent
N/A N/A
N/A
PS4 PSU.Slot.4 Online
2.73 A 228
16
RACADM sub command details