CLI Guide

● Display status of fan module 3 in the chassis.
racadm getmodinfo -m fan-3
getniccfg
Description Displays the network settings for modules.
Synopsis
racadm getniccfg [-m <module>]
Input -m—The <module> must be one of the following values:
● chassis—Default state if -m is not specified.
● switch-<n>—Where n = 1–6
Example
● Display switch network settings
racadm getniccfg -m switch-1
● Display chassis network settings
racadm getniccfg -m chassis
getpbinfo
Description
Gets power budget status information. If there is no power supply to the PSU, the output of the
command is displayed as Input Lost. If there is a mismatch in the power source, for example, a PSU
of 220 Volts and PSU of 110 Volts are combined, then the output of the command is displayed as
Configuration Error.
Synopsis
racadm getpbinfo
Input
racadm getpbinfo
Example
racadm getpbinfo
[Power Budget Status]
System Input Power = 615 W (2098 BTU/h)
Peak System Power = 628 W (2142 BTU/h)
Peak System Power Timestamp = 11:37:36 08/08/2018
Minimum System Power = 606 W (2067 BTU/h)
Minimum System Power Timestamp = 10:16:08 08/06/2018
Overall Power Health = Not OK
Redundancy = No
System Input Power Cap = Disabled
Redundancy Policy = None
Dynamic PSU Engagement Enabled = Not Applicable
System Input Max Power Capacity = 11571 W
Input Redundancy Reserve = Not Applicable
Input Power Allocated to Servers = Not Applicable
Input Power Allocated to Chassis Infrastructure = Not Applicable
Total Input Power Available for Allocation = 2385 W (8137 BTU/h)
Standby Input Power Capacity = Not Applicable
Server Based Power Management Mode = Not Applicable
Max Power Conservation Mode = Not Applicable
Server Performance Over Power Redundancy = Not Applicable
Power Available for Server Power-on = Not Applicable
Extended Power Performance(EPP) Status = Not Applicable
20 RACADM sub command details