API Guide

"JobId": 26097,
"Id": 25915,
"Data": "",
"TargetType":
{
"Id": 1000,
"Name": "DEVICE"
}
}
],
"Params": [],
"Visible": true,
"Editable": true,
"Builtin": false
}
Table 122. Attributes (continued)
Attribute Description
Target Id ID of the device.
SlotNumber The supported slot numbers are:
● 1-8 for computes
● 1-6 for IOMs
Slot Type The supported slot types are:
● 2000 for computes
● 4000 for IOM
PowerState The supported values are:
● 2 (Power On)—Transitions the system to "power on"
state. The corresponding ACPI state is G0/S0.
● 5 (Power Cycle (Off Soft))—Turns off the system. The
corresponding ACPI state is G2/S5, in which the system
consumes a minimal amount of power. The system, then,
transitions to "power on" state. The corresponding ACPI
state for "power on" is G0/S0.
● 8 (Power Off – Soft Non-Graceful)—Transitions the
system to off state. The corresponding ACPI state G2/S5,
in which the system consumes a minimal amount of power.
● 10 (Active Bus Reset)—Performs hardware reset on the
system.
● 12 (Power Off - Soft Graceful)—Performs an orderly
transition to "power off" state. The corresponding ACPI
state is G2/S5, in which the system consumes a minimal
amount of power.
Override Ignores device state and performs the operation
upInterfaceIds Id of the port that must be configured or switched. If there
are multiple ports, a "," is used in the parameter to separate
them.
mtuSize You can determine the MinMtu and MaxMtu
for a port from /DeviceService/Devices(id)/
InventoryDetails('portInformation'). The
mtuSize must be a value within this range.
Target Device ID retrieved from /api/DeviceService/Devices
logSelector The supported values are:
● 0—collect hardware logs
● 1—collect operating system logs
● 2—collect raid controller logs
shareType The supported share types are:
Monitor 399