Users Guide

ManualsBrandsDell ManualsActive System ManagerOpenManage Enterprise-Modular

117

118

119

120

121

122

123

124

125

126

Table 25. Command description

Command Description

OS10# show image status View the current software download status.

e. Install the 10.5.0.5 software image in EXEC mode.

Table 26. Command description

Command Description

OS10# image install image-url

Example:

OS10# image install image://filename.bin

Install the software image.

f. (Optional) View the status of the current software install in EXEC mode.

Table 27. Command description

Command Description

OS10# show image status View the status of the current software install.

g. Change the next boot partition to the standby partition in EXEC mode. Use the active parameter to set the next boot

partition from standby to active.

Table 28. Command description

Command Description

OS10# boot system standby Change the next boot partition to standby.

h. (Optional) Check whether the next boot partition has changed to standby in EXEC mode.

Table 29. Command description

Command Description

OS10# show boot detail Check whether the next boot partition has changed.

i. Reload the new software image in EXEC mode.

Table 30. Command description

Command Description

OS10# reload Reload the new software.

j. After the installation is complete, enter the show version command to check if the latest version of the software that you

have installed is running in the system.

The example below shows that the 10.5.0.5 software is installed and running on the system.

OS10# show version

MX9116N-A2# show version

Dell EMC Networking OS10 Enterprise

OS Version: 10.5.0.5

Build Version: 10.5.0.5.661

Build Time: 2020-02-15T00:45:32+0000

System Type: MX9116N-ON

Architecture: x86_64

Up Time: 1 day 20:37:53

MX9116N-A2#

2. Run the command, show smartfabric cluster member, in the Master networking switch. Confirm that the STATUS

of the upgraded switch is ONLINE in the command output, after it has reloaded. The networking switches with version

10.5.01 and higher uses SFS CLI, whereas the lower versions like 10.4.0E(R3S) and 10.4.0E(R4S) use python /opt/

dell/os10/bin/rest-service/tool/dnv_cli.py show cluster command. For steps to identify the master IOM,

see upgrading from versions earlier than 10.5.0.5 section.

Upgrading networking switch using CLI

125