CLI Guide

○ server
○ switch
If the module type is not specified, the default type is server.
NOTE: Switches must support Ethernet management.
● -u—The username for servers must be 'root'.
● -p—Password for the given username. For a server, the password must be 1-20 characters with
ASCII value in the 32-126 range.
NOTE: FC IOMs (MXG610s) do not support colon, ":", in passwords.
NOTE: You can configure only the "root" user password for servers, using the deploy command.
● -s— The <ipaddress> <subnet> <gateway> sets static IPV4 network configuration for
server. The <ipAddress>, <netmask>, and <gateway> must be typed as dotted decimal strings.
● -s—The attribute string, -6 <ipv6Address> <prefixlen> <gateway>, sets static IPV6
network configuration for server. The attributes, <ipv6Address> and <gateway>, must be
entered as colon separated IPV6 strings.
● -d—Enables DHCP for the specified server.
● -d—[-6] : enables DHCP for the specified server. The -6 option enables IPV6 autoconfiguration.
● -v—The SNMPv2 <snmpCommunityString> ro string sets the protocol version to SNMPv2, the
community string, and the permission as read-only. The length of the snmpCommunityString must
be 1-20 characters with ASCII value in the 32-125 range.
Example
● Set root password, configure static IPv4 address for server-1
racadm deploy -m server-1 -u root -p <password> -s 192.168.0.20
255.255.255.0 192.168.0.1
● Set root password, configure static IPv6 address for server-1
racadm deploy -m server-1 -u root -p <password> -s -6 2001:DB8::2 64
2001:DB8::1
● Set root password and enable DHCP for server-3
racadm deploy -m server-3 -u root -p <password> -d
● Set root password and enable IPv6 DHCP for server-3
racadm deploy -m server-3 -u root -p <password> -d -6
● Set password for switch-1
racadm deploy -m switch-1 -u root -p <password>
● Set SNMP community string for switch-1
racadm deploy -m switch-1 -v SNMPv2 DemoCommunityString ro
● Set root password to "calvin" for all servers
racadm deploy -a -u root -p calvin
● Set password for all switches
racadm deploy -a switch -u root -p <password>
faultlist
Description
Displays the active error message in the chassis subsystem.
RACADM sub command details 15