Users Guide

2. Click Devices > Compute. A list of the available compute devices in the chassis or chassis group is displayed.
3. In the list header, select the checkbox to select all compute devices on the current page. If there are multiple pages, then go
to each page and select the checkbox.
4. After selecting all the compute devices, click Update.
5. In the Device Update wizard, select the individual package and click Browse to select the iDRAC with Lifecycle
Controller DUP.
6. Once the DUP is uploaded, click Next and select the Compliance checkbox.
7. Click Finish to start the update on all compute devices.
8. Allow the job to complete before proceeding to update the components, Dell EMC Server BIOS PowerEdge MX740c,
MX750c, and MX840c.
NOTE: Updating iDRAC to 4.40.10.00 using individual DUPs from OME-M version 1.10.20 or lower does not display
compliance details and may fail. Please use the recommended catalog update method.
NOTE: As an alternative method of updating compute hosts and/or storage sleds, you can implement catalog based
updates once the catalogs are updated with the baseline versions. For more information, see Managing catalogs.
Updating PowerEdge MX740c, MX750c, and MX840c Server BIOS
Repeat the steps described in the section, Updating iDRAC with Lifecycle Controller using OME-Modular, to update Dell EMC
Server BIOS PowerEdge MX740c, MX750c, and MX840c as applicable.
Updating adapters
Download and install the operating system drivers for your device adapter that released with the device adapter firmware.
Follow the device adapter driver installation instructions for your operating system.
Repeat the steps described in the section to update the following adapter firmware:
Follow this section
To update
Updating iDRAC with Lifecycle Controller using OME-Modular QLogic 26XX series Fibre Channel adapters
QLogic 27XX series Fibre Channel adapters
QLogic 41xxx series adapters
Broadcom 57504 Quad Port device adapter
Mellanox ConnectX-4 Lx Ethernet Adapter Firmware
Intel NIC Family Version 19.5.x Firmware for X710, XXV710,
and XL710 adapters
Emulex Picard-16/Picard-32 adapters
Go to dell.com to download the latest device drivers associated with the firmware update.
Updating OME-Modular to 1.30.10
You can update to OME-Modular 1.30.10 from different versions. For more information, see OME-M firmware update matrix
section.
NOTE: If you select all the management modules in an MCM group, OME-M updates them in a required order.
NOTE: Updating to 1.10.x or later may result in the alert log alert HWC7522. You may have to perform a system reseat
power action on the MX7116n or pass-through module (PTM) IOMs.
NOTE: If the firmware update of a member chassis is nonresponsive for more than two hours, cancel the job using Stop
Job option on the Job Details page. Check the firmware update status on the member chassis directly. The Stop Job
option would stop the firmware update on specific target which was nonresponsive and goes to the next target update.
20 Updating firmware for PowerEdge MX solution