CLI Guide

Table 136. ProcX2Apic (continued)
● On Dell’s YX2X and later systems: Enabled, Disabled
Description
Enables or disables the x2APIC mode.
Example:
A:>syscfg --ProcX2Apic=Enabled
ProcX2Apic=Enabled
SATA Settings
You can manage the BIOS SATA settings using the options in this group.
EmbSata or embsataraid
Table 137. EmbSata or embsataraid
Valid Arguments
● On systems prior to Dell’s YX2X systems: off, combined, ata, ahci, raid, qdma
● On Dell’s YX2X and later systems: Off, AtaMode, RaidMode, AhciMode
Description
Configures an embedded SATA RAID controller. This option can be replicated.
● off /Off — disables the embedded SATA RAID controller.
● combined— sets the SATA RAID controller to combined mode.
● ata/ AtaMode— sets SATA RAID controller to ATA mode.
● ahci/ AhciMode— sets ATA RAID controller to ahci mode.
● raid/RaidMode — sets SATA RAID controller to RAID mode.
● qdma — sets the SATA RAID controller to support ATAPI devices at transfer
rates much higher than PIO. A device driver must be installed on your system to
use the QDMA mode.
Example:
A:>syscfg --embsataraid=off
embsataraid=off
eSataPort1Capacity
Table 138. eSataPort1Capacity
Valid Arguments
● On systems prior to Dell’s YX2X systems: NA
● On Dell’s YX2X and later systems: read-only
Description
Displays the total capacity of a hard-disk drive. This option is undefined for
removable-media devices such as optical drives.
Example:
A:>syscfg --eSataPort1Capacity
SYSCFG 75