CLI Guide

Table 86. AssetTag or asset (continued)
● On YX2X and later systems: read-only
Description Reports or sets the customer-programmable asset tag number for a system. This
value can be replicated.
NOTE: The Asset Tag is a string assigned to a system, usually by an
administrator, for security or tracking purposes. The Asset Tag can be up to 10
characters long and can contain only printable US-ASCII characters. For more
information on delimiters, see Command Line Option Delimiters.
Example:
A:>syscfg --asset=<ASSETTAG>
asset=ASSETTAG
ErrPrompt or f1f2promptonerror
Table 87. ErrPrompt or f1f2promptonerror
Valid Arguments
● On systems prior to YX2X: enable, disable
● On YX2X and later systems: Enabled, Disabled
Description
Enables or disables the BIOS to prompt F1 or F2 error codes.
Example:
A:>syscfg --f1f2promptonerror=enable
f1f2promptonerror=enable
InSystemCharacterization
Table 88. InSystemCharacterization
Valid Arguments
● On systems prior to YX2X: NA
● On YX2X and later systems: FastBoot, OptimizedBoot, Disabled
Description
In-System Characterization (ISC) runs during power-on self-test (POST) on
detecting relevant changes in the system configuration to optimize power and
performance. ISC takes about 20 seconds to run, and a system restart is required to
apply the system configuration changes. The FastBoot option runs ISC and
continues without applying ISC results until the next system restart. The
OptimizedBoot option runs ISC and forces an immediate system restart to apply
the results. If set to Disabled, ISC does not run.
Example:
A:>syscfg --InSystemCharacterization=FastBoot
InSystemCharacterization=FastBoot
SYSCFG 59