CLI Guide

Table 73. MemOpVoltage or dimmvoltage (continued)
● On YX2X and later systems: AutoVolt, Volt15V
Description
Sets the DIMM voltage selection. When set to AutoVolt(default value), the
system automatically sets the voltage to the optimal setting based upon the DIMM
capability and the installed DIMM population. This option also enables setting the
system DIMM voltage to a higher (1.5V) setting if the DIMMs support multiple
voltages and have been set to a lower voltage.
NOTE: Volt15V represents 1.5 Volt.
Example:
A:>syscfg --dimmvoltage=auto
dimmvoltage=auto
MemTest or memtest
Table 74. MemTest or memtest
Valid Arguments
● On systems prior to YX2X: enable, disable
● On YX2X and later systems: Enabled, Disabled
Description
Enables or disables the POST extended memory test.
Example:
A:>syscfg --MemTest=Enabled
MemTest=Enabled
NodeInterleave or nodeinterleave
Table 75. NodeInterleave or nodeinterleave
Valid Arguments
● On systems prior to YX2X: enable, disable
● On YX2X and later systems: Enabled, Disabled
Description
Enables node interleaving, if the system is configured with matching memory. If set
to disable (default), the system supports Non-Uniform Memory (NUMA)
architecture memory configurations. This field is active only if the memory
configuration can support node interleaving.
NOTE: The nodeinterleave option is same as memintleave option. For
more information, see memintleave.
Example:
A:>syscfg --nodeinterleave=enable
nodeinterleave=enable
SYSCFG 55