CLI Guide

Table 32. EmbNic4 or embnic4 (continued)
Description
Turns the fourth embedded NIC on with PXE enabled, off, or on without PXE
enabled. This option is only valid for supported systems that have four embedded
NICs. If the fourth NIC is enabled without PXE, it is not found in the boot order. If
the fourth NIC is turned on with PXE, it is placed at the end of the boot order. The
onnopxe argument is not supported on all systems. This option can be replicated.
The onwithiscsi argument enables the embedded NIC to boot from the iSCSI
server. The embnic4 option can be replicated.
Example:
A:>syscfg --embnic4=onnopxe
embnic4=onnopxe
EmbVideo or embvideoctrl
Table 33. EmbVideo or embvideoctrl
Valid Arguments
● On systems prior to YX2X: enable, disable
● On YX2X and later systems: Enabled, Disabled
Description
Enables or disables the BIOS support for the Embedded Video Controller
Example:
A:>syscfg --embvideoctrl=enable
embvideoctrl=enable
IoatEngine or ioat
Table 34. IoatEngine or ioat
Valid Arguments
● On systems prior to YX2X: enable, disable
● On YX2X and later systems: Enabled, Disabled
Description
Enables or disables the I/O Acceleration Technology (I/OAT) DMA Engine option.
This option must be enabled only if the hardware and software support I/OAT on
your system. This option can be replicated.
Example:
A:>syscfg --ioat=enabled
ioat=enabled
IntegratedNetwork1
Table 35. IntegratedNetwork1
Valid Arguments
● On systems prior to YX2X: NA
● On YX2X and later systems: Enabled, DisabledOs
42 SYSCFG