CLI Guide

Table 374. RAIDCFG Error Codes and Messages (continued)
Error Code Message
204 File is not writable!
205 Setting Environment Variable Command failed!
206 Filename is not provided!
207 Invalid Strict option! Please provide a valid number between 1 and 100.
208 Span depth is not needed for this RAID type.
209 Array disk(s) cannot be part of virtual disk(s) and also be hotspares.
210 Cannot have silent and logfile switch with the same command.
211 Invalid array disk(s)!
212 Invalid failover disk(s)!
213 Creation of a virtual disk on this RAID controller requires the use of
the entire disk space of the array disks. The size or - sz parameter is
not needed.
214 Invalid size given! size=max or -sz=max is not supported for this RAID
controller.
215 The value given for envname or -envn is null or too long.
216 Invalid virtual disk size!
217 The strict option provided failed! Virtual disk is not created.
218 Unable to determine optimum size for Virtual disk. Ensure that the array
disks are of the same protocol (i.e. SAS, SATA, SCSI). If there is a
mismatch of the array disks then the RAIDCFG will not be able to
determine the optimum size. In addition, also ensure that there is drive
size available for the specified virtual disk.
219
One or more array disks selected to create virtual disk or hotspare
doesn't have enough disk space. Please make sure that all the array
disks and failover drives selected have enough free space.
220 The number of array disks provided is incorrect for the requested RAID
Type! RAID 1 requires exactly 2 array disks, RAID 5 requires at least 3
array disks, RAID 10 requires at least 4 array disks and RAID 50
requires at least 6 array disks.
221
No free array disks found!
222 No global failover disks found!
223 One or more array disks selected for the virtual disk has foreign
configuration.
224 Error in opening the file.
225 SAS 5/IR, SAS 6/IR, H200 and SW RAID requires atleast two physical disks
to create RAID 0 or RAID 1.
226 No Foreign configuration present in the controller.
227 The virtual disk cannot be created on the physical disks you selected.
Possible reasons include:unsupported mix of SAS and SATA protocol type
disks, unsupported mix of SSD and HDD media disks.
228 Unsupported array disks selected for VD creation.
229 Setting stripe size is not supported in this controller.
220 Messages And Codes