CLI Guide

Table 369. SYSCFG Error Codes and Messages (continued)
Error Code Message
82 The CPU information is not available.
83 The dependent option required for this subcommand is missing in the
command line.
84 Duplicate sub command has been entered.
85 The script file does contain not a valid DTK environment script
signature.
86 The format of the environment variable is incorrect.
87 The --envar option can only be used for a single option.
88 The --envar option can only be used for report operations.
89 The individual sub commands should be specified for the -s option.
90 Getting external serial connector settings failed.
91 Setting external serial connector settings failed.
92 There was an error opening the file.
93 File does not have write permission.
94 The file contains invalid options.
95 The replication information does not match for this system.
96 There can only be one section in the input file.
97 Bad ini file, the section cannot be found.
98 The format of the bios image file is incorrect.
99 Report operations and set operations must be separate.
100 Help is not available for the option.
101 The -x (--hex) option can only be used with -b or -r.
102 Input file not found.
103 Input file cannot be read.
104 Invalid argument for option.
105 Function table lookup error.
106 The machine ID was not found in the file.
107 The system memory information is not available.
108 Mode can only be used with the --pci option.
109 The device name or index must be present in the boot order.
110 The output file could not be opened. Please make sure the path exists
and the media is not write protected.
111 Could not write to output file, disk may be full.
112 The current password must be supplied with a new password using --
oldsyspwd.
113 The current password must be supplied with a new password using --
oldsetuppwd.
114 The current password can only be supplied when setting a new password.
115 Actions are not allowed for this filter. Only alerts are allowed.
208 Messages And Codes