CLI Guide

Table 277. opticaldrivectrl (continued)
Example:
A:>syscfg --opticaldrivectrl=enable
opticaldrivectrl=enable
power
Table 278. power
Valid Arguments NA
Description
For details about the power suboptions and arguments, see Sub Options For Power
Option.
remflashmedia
Table 279. remflashmedia
Valid Arguments read-only
Description
Displays the redundancy status of internal dual SD module. The status can be:
● Full — Secure digital card (SD) 1 and 2 are functioning properly.
● Lost — Either any of the secure digital cards or both are not functioning
properly.
The option also displays the status of the individual SD cards as follows:
● Active — The card is used for secure digital reads.
● Standby — The card is receiving a copy of all secure digital reads.
● Failed — An error is reported during a secure digital read or write.
● Absent — No secure digital media is detected.
● Offline — At boot, card identification signature is different from the non-volatile
storage value or card is the destination of a copying operation that is in progress.
● Write Protected — The card is write-protected.
Example:
A:>syscfg --remflashmedia
Internal Dual SD ModuleRedundancy=Lost
SD1 status=Absent
SD1 status=Active
redmem
Table 280. redmem
Valid Arguments off, spare, mirror, DDDC
Description
Allows selection of the required redundant memory mode, or disables redundant
memory. This option can be replicated.
SYSCFG 123