CLI Guide

OneTimeUeBootSeqDev
Table 99. OneTimeUeBootSeqDev
Valid Arguments
• On systems prior to 12G: NA
• On 12G and later systems: numerical list separated by commas or list of device names
separated by commas
Description
Determines the one-time boot device when the One-Time Boot Device List is set to UEFI
Boot Sequence Device. If Boot Mode is set to BIOS, the system temporarily switches the
Boot Mode to UEFI when attempting a one-time boot to the device.
Example:
A:>syscfg --OneTimeUefiBootSeqDev= 2,3,4,5,1,6
The following devices are set in the boot sequence:
Device 2:* usbcdrom.slot.1- USB CD-ROM device
Device 3:* virtualcd.slot.1 – VIRTUAL CDROM
Device 4:* hdd.emb.0 -Hard drive C:
Device 5:* nic.emb.1 - MBA v2.5.12 Slot 0500
Device 1:* virtualfloppy.slot.1 - VIRTUAL FLOPPY
Device 6:* usbfloppy.slot.1 - USB Floppy device
NOTE: The asterisk indicates that the device is enabled in the BIOS.
Applicable Systems PowerEdge 12G and later systems.
Processor Settings
You can manage the processor settings using the options in this group.
DataReuse or datareuse
Table 100. DataReuse or datareuse
Valid Arguments
• On systems prior to 12G: enable, disable
• On 12G and later systems: Enabled, Disabled
Description
Enables (default value) or disables data reuse in cache. Set to enable for High Performance
Computing (HPC) applications. Set to disable for energy eciency. This option can be
replicated.
A:>syscfg --datareuse=enable
datareuse=enable
Applicable Systems PowerEdge 11G and later systems
SYSCFG 75