CLI Guide
AssetTag or asset
Table 87. AssetTag or asset
Valid Arguments
• On systems prior to 12G: read-only
• On 12G and later systems: read-only
Description Reports or sets the customer-programmable asset tag number for a system. This value can
be replicated.
NOTE: The Asset Tag is a string assigned to a system, usually by an administrator,
for security or tracking purposes. The Asset Tag can be up to 10 characters long
and can contain only printable US-ASCII characters. For more information on
delimiters, see Command Line Option Delimiters.
Example:
A:>syscfg --asset=<ASSETTAG>
asset=ASSETTAG
Applicable Systems All PowerEdge systems except Blade systems
ErrPrompt or f1f2promptonerror
Table 88. ErrPrompt or f1f2promptonerror
Valid Arguments
• On systems prior to 12G: enable, disable
• On 12G and later systems: Enabled, Disabled
Description
Enables or disables the BIOS to prompt F1 or F2 error codes.
Example:
A:>syscfg --f1f2promptonerror=enable
f1f2promptonerror=enable
Applicable Systems PowerEdge 10G and later systems
InSystemCharacterization
Table 89. InSystemCharacterization
Valid Arguments
• On systems prior to 12G: NA
• On 12G and later systems: FastBoot, OptimizedBoot, Disabled
Description
In-System Characterization (ISC) runs during power-on self-test (POST) on detecting
relevant changes in the system conguration to optimize power and performance. ISC takes
about 20 seconds to run, and a system restart is required to apply the system conguration
changes. The FastBoot option runs ISC and continues without applying ISC results until
70 SYSCFG