CLI Guide

not found in the boot order. If the NIC is turned on with PXE, it is placed at the end of the
boot order. The onnopxe argument is not supported on all systems.
The onwithiscsi argument enables the embedded NIC to boot from the iSCSI server. The
embnic1 option can be replicated.
Example:
A:>syscfg --embnic3=onnopxe
embnic3=onnopxe
Applicable Systems All PowerEdge systems
EmbNic3Nic4 or embnic3nic4
Table 32. EmbNic3Nic4 or embnic3nic4
Valid Arguments
• On systems prior to 12G: enable, disable
• On 12G and later systems: Enabled, Disabled, DisabledOs
Description
Enables or disables the operating system interface of the third and fourth embedded NIC
controllers.
Example:
A:>syscfg --EmbNic3Nic4=enable
--embnic3nic4=enable
Applicable Systems PowerEdge 11G and later systems
EmbNic4 or embnic4
Table 33. EmbNic4 or embnic4
Valid Arguments
• On systems prior to 12G: on, o, onnopxe, onwithiscsi
• On 12G and later systems: Enabled, EnabledPxe, EnablediScsi, Disabled
Description
Turns the fourth embedded NIC on with PXE enabled, o, or on without PXE enabled. This
option is only valid for supported systems that have four embedded NICs. If the fourth NIC
is enabled without PXE, it is not found in the boot order. If the fourth NIC is turned on with
PXE, it is placed at the end of the boot order. The onnopxe argument is not supported on all
systems. This option can be replicated.
The onwithiscsi argument enables the embedded NIC to boot from the iSCSI server. The
embnic4 option can be replicated.
Example:
A:>syscfg --embnic4=onnopxe
embnic4=onnopxe
Applicable Systems All PowerEdge systems
50 SYSCFG