CLI Guide

Option Sub-option Valid Arguments Description
Example:
A:>syscfg solaction
--userid=2 --action=disable
solaction userid=2
action=disable
--userid
2–16, if your system has
a DRAC 5 controller
Species the BMC user ID. This sub-option can be
replicated.
--action enable, disable
Enables or disables the user ID specied using the
userid sub-option. This sub-option can be
replicated and is dependent on the userid sub-
option.
solcfgparams
Table 324. solcfgparams
Option Sub-option Valid Arguments Description
solcfgparams
Congures and displays SOL conguration
parameters. This option can be replicated.
--solenable enable, disable
Enables or disables if the SOL payload type can
be activated. This option can be replicated.
--solprivlevel user, operator,
administrator
Sets the minimum user privilege level required to
activate the SOL. This option can be replicated.
--solcharaccuminterval 1–255
Sets the Character Accumulate Interval in 5–ms
increments (1–255). This sets the typical amount
of time that the BMC waits before transmitting a
partial SOL character data packet. This option
can be replicated.
--solcharsendthreshold 1–255
Species that the BMC automatically sends an
SOL character data packet containing this
number of characters in increments of 5 (1–255)
as soon as this number of characters (or greater)
has been accepted from the baseboard serial
controller into the BMC. This option can be
replicated.
--solbitrate
9600, 19200
Sets the serial channel communication bit rate
(in bps) with the BMC when SOL is activated.
This option can be replicated.
NOTE: The arguments for solbitrate
vary with various Dell systems. If an
argument valid for a particular Dell
system is entered for another system,
the Parameter out of range error
is displayed.
170 SYSCFG