CLI Guide

SYSCFG Options On PowerEdge Systems Prior To PowerEdge
12G Systems
The following are the valid options and arguments supported on PowerEdge systems earlier than PowerEdge 12G systems.
assignintr
Table 245. assignintr
Valid Arguments standard, distributed
Description Controls the interrupt assignment of PCI devices in the system. This option is set to
standard by default, causing standard interrupt routing that uses interrupt A, B, C, and D for
all PCIe devices. When set to distributed, the interrupt routing is swizzled at the MCH root
ports to minimize sharing of interrupts across all PCIe (and PCI-X in the Programmable
Interrupt Controller (PIC) mode) devices.
Example:
A:>syscfg --assignintr=standard
assignintr=standard
Applicable Systems All PowerEdge systems prior to PowerEdge 12G systems
bezelir
Table 246. bezelir
Valid Arguments enable, disable
Description Enables or disables the ESM to monitor and log front bezel intrusion conditions.
Example:
A:>syscfg --bezelir=enable
bezelir=enable
Applicable Systems All PowerEdge systems prior to PowerEdge 12G systems
cmosdefaults
Table 247. cmosdefaults
Valid Arguments enable, disable
Description
Enables or disables the request for a default CMOS value during the next reboot.
A:>syscfg --cmosdefaults=enable
cmosdefaults=enable
Applicable Systems All PowerEdge systems prior to PowerEdge 12G systems
132 SYSCFG