Users Guide

Table 2. DTKTORACADM Command on Linux Operating System
Valid Arguments python dtktoracadm.py or python dtktoracadm.py linux_scripts.lst debug
Description On the system running Linux operating system, in the prompt type the command, where
linux_scripts.lst is the input which contains the list of path to run the RACADM scripts and debug is
an option which list the le status.
Applicable Systems
All PowerEdge 12 and later systems.
The set of converted commands are available in dtktoracadm_dict.map. For more information see, Dell EMC OpenManage Deployment
Toolkit User's Guide or Dell EMC OpenManage Deployment Toolkit Installation Guide. The following table lists the set of commands
available:
Table 3. SYSCFG equivalent RACADM commands
Group SYSCFG Commands Equivalent RACADM Commands
iDRAC Settings
lcp --dnsdhcp iDRAC.IPv4.DNSFromDHCP
lcp --domainname iDRAC.NIC.DNSDomainName
lcp --dnsracname iDRAC.NIC.DNSRacName
lcp --dnsregisterrac iDRAC.NIC.DNSRegister
--idractype iDRAC.Info.Type -z legacy
--autoneg iDRAC.NIC.Autoneg
--gateway iDRAC.IPv4.Gateway
--ipaddress iDRAC.IPv4.Address
--macaddress iDRAC.NIC.MACAddres
--nicselectionfailover iDRAC.NIC.Failover
--subnetmask iDRAC.IPv4.Netmask
--vlanid iDRAC.NIC.VLanID
--dnsserver1v6 get iDRAC.IPv6.DNS1
--dnsserver2v6 get iDRAC.IPv6.DNS2
--gatewayv6 iDRAC.IPv6.Gateway
--ipv6address1 iDRAC.IPv6.Address1
--ipv6address2 iDRAC.IPv6.Address2
--linklocaladdrv6 iDRAC.IPv6.LinkLocalAddress
--prexlengthv6 iDRAC.IPv6.PrexLength
--connectionmode iDRAC.IPMISerial.ConnectionMode
--msgcommbitrate iDRAC.IPMISerial.BaudRat
--msgcommowctrl iDRAC.IPMISerial.FlowControl
--tmcfghandshakectrl iDRAC.IPMISerial.HandshakeControl
--tmcfglineediting iDRAC.IPMISerial.LineEdit
--tmcfgnewlineseq iDRAC.IPMISerial.NewLineSeq
8 Introduction