CLI Guide

Applicable Systems All PowerEdge 11G and later systems
BootSeqRetry or bootseqretry
Table 23. BootSeqRetry or bootseqretry
Valid Arguments
• On systems prior to 12G: enable, disable
• On 12G and later systems: Enabled, Disabled
Description Enables or disables the boot sequence retry feature. When set to enable, the system re-
attempts to set the boot order after a 30-second time-out if the last boot attempt has
failed. This option can be replicated.
A:>syscfg --bootseqretry=enable
bootseqretry=enable
Applicable Systems All PowerEdge systems
HddFailover or hddfailover
Table 24. HddFailover or hddfailover
Valid Arguments
• On systems prior to 12G: o, on
• On 12G and later systems: Enabled, Disabled
Descriptiono
Species the device in the Hard Disk Drive Sequence menu that has not been attempted in
the boot sequence. When set to on, all devices are attempted in an order in which they are
congured. When set to o, only the rst device in the hard disk sequence is attempted.
This option can be replicated.
Example:
A:>syscfg --hddfailover=on
hddfailover=on
Applicable Systems All systems except PowerEdge 12G systems.
SetBootOrderFqdd n
Table 25. SetBootOrderFqdd
n
Valid Arguments
• On systems prior to 13G: NA
• On 13G and later systems: <string>
Description
Displays the list of FQDDs representing the boot list to be applied on the next boot.
NOTE: The value of n in SetBootOrderFqdd n can be 1–16.
SYSCFG 47