CLI Guide

Error Code Message
218 Unable to determine optimum size for Virtual disk. Ensure that the array
disks are of the same protocol (i.e. SAS, SATA, SCSI). If there is a
mismatch of the array disks then the RAIDCFG will not be able to determine
the optimum size. In addition, also ensure that there is drive size
available for the specified virtual disk.
219 One or more array disks selected to create virtual disk or hotspare doesn't
have enough disk space. Please make sure that all the array disks and
failover drives selected have enough free space.
220 The number of array disks provided is incorrect for the requested RAID Type!
RAID 1 requires exactly 2 array disks, RAID 5 requires at least 3 array
disks, RAID 10 requires at least 4 array disks and RAID 50 requires at least
6 array disks.
221 No free array disks found!
222 No global failover disks found!
223 One or more array disks selected for the virtual disk has foreign
configuration.
224 Error in opening the file.
225 SAS 5/IR, SAS 6/IR, H200 and SW RAID requires atleast two physical disks to
create RAID 0 or RAID 1.
226 No Foreign configuration present in the controller.
227 The virtual disk cannot be created on the physical disks you selected.
Possible reasons include:unsupported mix of SAS and SATA protocol type
disks, unsupported mix of SSD and HDD media disks.
228 Unsupported array disks selected for VD creation.
229 Setting stripe size is not supported in this controller.
230 Invalid VirtualDisk(VD) name specified. VD name can have alphanumeric
characters [A-Z,a-z,0-9,_,-] only. Also, VD name size must be less than or
equal to 15 characters
231 Error occurred while setting virtual disk as boot disk.
232 Error occurred while setting name for virtual disk.
233 Couldn't get boot virtual disk.
234 PCIe Link Speed could not be set for the RAID controller. Please check if
the controller has the capability to set/change its PCIe link speed.
235 PCIe Link Speed can be set to either 2 or 3 i.e. PCIe Generation 2.0 or 3.0.
236 PCIe Link Speed could not be retrieved for this RAID controller.Please check
if the controller has the PCIe link speed capability.
237 Please reset the controller before doing any further operation.
238 Boot Mode can be set to 0 (BIOS stop on error), 1 (BIOS continue on error),
2 (Headless continue on error)
239 Boot Mode could not be set for the RAID controller.
242 Messages And Codes