CLI Guide
Table 372. SYSCFG Failures and Solutions
Failure Messages Solutions
Generic failure. Indicates iDRAC is in bad state. Reboot iDRAC.
New value not valid. Make sure the changed value is valid.
Cannot disable this orderedList’s entries. BIOS does not support enabling or disabling of a particular boot order object.
System busy, try again later. Retry as iDRAC is busy with internal processing.
Unable to connect iDRAC data manager. Start data manager service using srvadmin_services (specic to Linux).
System Services and/or CSIOR disabled. Enable CSIOR from <F2> screen.
UPINIT Common Error Codes And Messages
The UPINIT utility checks your commands for correct syntax. When you enter a command, a message is displayed stating the results of the
command.
Failure Messages
The UPINIT utility failure messages provide error codes to help diagnose why some commands do not succeed. Table below lists error
codes and messages common to Linux and Microsoft Windows PE environments.
Table 373. UPINIT Common Error Codes and Messages
Error Code Message
0 Dell Utility Partition created successfully.
1 Error: Disk ID not specified.
2 Error: SIZE not specified.
3 Error: Utility Partition Image file not specified.
4 Error: DRMK Path not specified.
5 Error: Dell Utility Partition already exits. Please use --overwrite option
to upgrade or overwrite.
6 Error: Partitions exists. Please clear all the partitions before running
upinit.sh.
7 Error: DOS file(s) not found at the specified path.
8 Error: UP IMAGE not found at the specified location.
9 Error: format failed.
10 Error: Invalid size. Size should be a number between 32 and 2000.
11 Error: sysdrmk failed.
12 System Error.
13 Error: Invalid Argument: <argument>
Messages And Codes 233