CLI Guide

Option Sub-option Valid Arguments Description
The destipaddr sub-option is dependent on the
alertdest sub-option. If the alertdest sub-
option is not specied on the command line, the
rst alert destination (
alertdest=1) is set with
this IP address or FQDN. This sub-option can be
replicated.
NOTE: FQDN is applicable only for
destipaddr option and is supported
only on PowerEdge 12G systems.
Example 1 (to set the destination IP address):
A:>syscfg lcp --alertdest=1 --
destipaddr=192.168.100.15
Example 2 (to set the destination IP address as
FQDN):
A:>syscfg lcp --alertdest=1 --
destipaddr=xxx.yyy.com
--alertdest 1, 2, 3, 4
Sets the destination for the LAN alert. This sub-
option can be replicated.
--vlantag enable,
disable
Enables or disables VLAN tagging. This sub-option
can be replicated.
--vlanid <string>
Sets the 12-bit VLAN ID. This sub-option can be
replicated.
--vlanpriority 0–7
Sets the VLAN priority value. This sub-option can
be replicated.
--macaddress
NA Displays the BMC MAC address. This sub-option
cannot be replicated.
--nicselection
NOTE: This option is
available only with the
appropriate installed license.
shared,
sharedfailover
, dedicated,
sharedreceiveo
nall
Sets the operating mode of the NIC to shared,
sharedfailover, dedicated, or
sharedreceiveonall. Some of these options
are not applicable on certain systems.
NOTE:
This option is applicable on systems prior to
PowerEdge 12G systems. The
sharedreceiveonall argument is available
only on PowerEdge 11G systems.
--nicselection
NOTE: This option is
available only with the
appropriate installed license.
dedicated,
lom1, lom2,
lom3, lom4
Sets the operating mode of the iDRAC7 NIC to
dedicated, lom1, lom2, lom3, or lom4. Some
of these options are not applicable on certain
systems due to underlying hardware.
NOTE: This option is applicable on
PowerEdge 11G systems.
--nicselectionfailover
NOTE: This option is
available only with the
appropriate installed license.
none, lom1,
lom2, lom3,
lom4, all
Sets the operating mode of the NIC selection
failover to none, lom1, lom2, lom3, lom4, or
all. Some of these options are not applicable on
certain systems. due to underlying hardware.
NOTE: This option is applicable on
PowerEdge 12G systems.
156 SYSCFG