CLI Guide

ProcX2Apic
Table 136. ProcX2Apic
Valid Arguments
● On systems prior to Dell’s 12th generation PowerEdge systems: NA
● On Dell’s 12th generation PowerEdge and later systems: Enabled, Disabled
Description
Enables or disables the x2APIC mode.
Example:
A:>syscfg --ProcX2Apic=Enabled
ProcX2Apic=Enabled
Applicable Systems Dell’s 12th generation PowerEdge and later systems
SATA Settings
You can manage the BIOS SATA settings using the options in this group.
EmbSata or embsataraid
Table 137. EmbSata or embsataraid
Valid Arguments
● On systems prior to Dell’s 12th generation PowerEdge systems: off, combined,
ata, ahci, raid, qdma
● On Dell’s 12th generation PowerEdge and later systems: Off, AtaMode,
RaidMode, AhciMode
Description
Configures an embedded SATA RAID controller. This option can be replicated.
● off /Off — disables the embedded SATA RAID controller.
● combined— sets the SATA RAID controller to combined mode.
● ata/ AtaMode— sets SATA RAID controller to ATA mode.
● ahci/ AhciMode— sets ATA RAID controller to ahci mode.
● raid/RaidMode — sets SATA RAID controller to RAID mode.
● qdma — sets the SATA RAID controller to support ATAPI devices at transfer
rates much higher than PIO. A device driver must be installed on your system to
use the QDMA mode.
Example:
A:>syscfg --embsataraid=off
embsataraid=off
Applicable Systems All PowerEdge systems
eSataPort1
Table 138. eSataPort1
Valid Arguments
● On systems prior to Dell’s 12th generation PowerEdge systems: NA
● On Dell’s 12th generation PowerEdge and later systems: Off, Auto
Description
Sets the embedded SATA port1 to auto or off.
SYSCFG 83