CLI Guide

Table 329. SYSCFG Options For State Configuration
Option Valid Arguments Description
-b or --byte <string>
Specifies a value to write to state data. The format of the argument must
be in decimal format unless the -x option is given. If the -x option is given,
the value is interpreted as hexadecimal format. The value can optionally
contain 0x. The decimal range is 0–255, and the hexadecimal range is
0x00–0xFF.
Example:
A:>syscfg -b 1
The state byte has been set to 1.
A:>syscfg -b 2 -x
The state byte has been set to 0x02.
-r or --read*
NOTE: The asterisk
is not part of the
command syntax.
NA
Reads the value of state data. When used with the -x option, the value is
reported in hexadecimal format (0xNN).
Example:
A:>sysfg -r -x
The state byte has been set to 0x02.
A:>syscfg -r
The state byte has been set to 2.
-x or --hex
None
Specifies that a value should be in hexadecimal format.
Example:
A:>sysfg -r -x
The state byte has been set to 0x01.
A:>sysfg -x -b 0x02
The state byte has been set to 0x02.
SYSCFG for System Configuration
SYSCFG enables system configuration and reporting. It reports system identification values, processor types and speeds,
memory size, and detects device using PCI scan.
Options For System Configuration
Table below documents valid options and arguments along with a description of the expected behavior of each option. Options
and arguments are case sensitive. All options and pre-defined arguments are lowercase unless stated otherwise.
NOTE:
Some of the following options or arguments might not be available on all systems. Some of the command line
options are followed by an asterisk. Such options are used for reporting purposes only.
SYSCFG 163