CLI Guide

Table 232. TpmInfo (continued)
Applicable Systems PowerEdge 13G and later systems
TpmCommand
Table 233. TpmCommand
Valid Arguments
● On systems prior to 13G: NA
● On 13G and later systems: None, Activate, Deactivate, Clear
Description
Configures the Trusted Platform Module (TPM).
● None
— Commands are not sent to the TPM.
● Activate — TPM is enabled.
● Deactivate — TPM is disabled.
● Clear — All the contents of TPM are cleared.
NOTE: This field is read-only when TpmSecurityis set to Off.
CAUTION: Clearing TPM results in loss of all keys in the TPM. This could
affect booting to operating system.
Example:
A:>syscfg --TpmCommand=Activate
Applicable Systems PowerEdge 13G and later systems
SecureBoot
Table 234. SecureBoot
Valid Arguments
● On systems prior to 12G: NA
● On 12G and later systems: Enabled.
Description
Enables the BootSeqRetry feature. When set to Enabled, the system re-attempts
the boot sequence after a 30-second timeout, if the last boot attempt has failed.
Example:
A:>syscfg --SecureBoot=Enabled
SecureBoot=Enabled
Applicable Systems PowerEdge 12G and later systems
SecureBootPolicy
Table 235. SecureBootPolicy
Valid Arguments
● On systems prior to 12G: NA
● On 12G and later systems: Standard, Custom
SYSCFG 115