CLI Guide

• On 12G and later systems: numerical list separated by commas or list of device names

separated by commas

Description

Sets the specied device as the rst device in the boot order for the next boot cycle only.

The device must be a device from the bootseq option device list. Run the bootseq option

to see a list of available device names. For more information, see --bootmode . This option is

not replicated. If Boot Mode is set to UEFI, the system temporarily switches the Boot

Mode to BIOS when attempting a one-time boot to the device.

Example:

A:>syscfg --OneTimeBootSeqDev= 2,3,4,5,1,6

The following devices are set in the boot sequence:

Device 2:* usbcdrom.slot.1- USB CD-ROM device

Device 3:* virtualcd.slot.1 – VIRTUAL CDROM

Device 4:* hdd.emb.0 -Hard drive C:

Device 5:* nic.emb.1 - MBA v2.5.12 Slot 0500

Device 1:* virtualfloppy.slot.1 - VIRTUAL FLOPPY

Device 6:* usbfloppy.slot.1 - USB Floppy device

NOTE: The asterisk indicates that the device is enabled in the BIOS.

Applicable Systems All PowerEdge systems.

OneTimeHddSeqDev

Table 98. OneTimeHddSeqDev

Valid Arguments

• On systems prior to 12G: NA

• On 12G and later systems: numerical list separated by commas or list of device names

separated by commas

Description

Determines the one-time boot hard disk when the One-Time Boot Device List is set to BIOS

Hard-Disk Drive Sequence Device. If Boot Mode is set to UEFI, the system temporarily

switches the Boot Mode to BIOS when attempting a one-time boot to the device.