CLI Guide

Error Code Message
240 Enable Auto Import can be set to 0 (No) or 1 (Yes).
241 Cannot discard the preserved cache because a foreign configuration is
present on the controller. Use '-ignoreconfig' or '-igncfg' to discard the
cache.
1000 Enable Auto Import property could not be set for the RAID controller.
1001 Invalid array disk list.
1002 Source or destination disk is in invalid state. Make sure that the source
disk is in online state, destination disk is in ready state, and the size of
the destination disk is greater than or equal to the size of the source
disk.
1003 Operation not allowed. Cannot set the array disk state to online.
1004 Operation not allowed. Cannot set the array disk state to offline.
1005 Invalid encrypted array disk list for the instant secure erase operation.
1006 Sector drives 512B and 4KB must not be combined while creating a virtual
disk.
1007 Hot spare sector size for the virtual disk is not matching.
1008 sectorsize parameter is not found.
1009 Warning! Cannot assign global hotspare. Input array disk can act as a
hotspare only for virtual disks with matching sector size (4KB or 512B) and
supported T10 PI capability. Use "-force" option to discard the warning.
1010 Force option is invalid for this operation on the specified controller.
1011 Input values for vdiskprotectioninfo and vdpi are 1 and 0.
1012 vdiskprotectioninfo or vdpi option is not available on the controller.
1013 Input array disks or hotspares are not PI-capable.
1014 Creation of RAID 10 virtual disk with Uneven Span failed.
1015 Spanlength is not required for creating a RAID10 virtual disk on this
controller.
1016 Unsupported operation. RAID 6 and RAID 60 virtual disks which are T10 PI
enabled do not support Slow Initialize.
1017 Operation is not supported. The specified controller does not have
encryption capability.
1018 Operation is not supported. Encryption key is not present on the specified
controller.
1019 The specified array disks or hotspares do not have encryption capability.
1020 The specified controller does not have a locked foreign configuration.
1021 Invalid passphrase.
1022 Input values for secureflag and sf are 1 and 0.
1023 Unsupported operation. Preserved cache is not present on the controller.
242 Messages And Codes