CLI Guide

Error Code Message
136 Version cannot be accompanied with any other option.
137 The self-identify blinker timer should be set to 0..255 second(s).
138 Encrypt key is too long.
139 Encrypt key is invalid, accepted characters are 0 to 9 or A to F.
140 Parameter has been temporarily disabled due to a dependency on other
settings.
141 The old password supplied is incorrect. The new password will not be set.
Please try again.
142 Cannot stat /etc/omreg.cfg file. Please ensure /etc/omreg.cfg file is
present and is valid for your environment. You can copy this file from the
DTK iso.
143 Getting nicselection settings failed.
144 HAPI Driver Load Error.
145 Filter action power reduction is only supported for the system power warn/
fail filters.
146 TPM/TCM Clear settings requires setup password.
147 There is currently no TPM/TCM Clear request pending.
148 Password is not required for retrieving the ’%s’ options.
149 Setup password is required for setting the ’%s’ options.
150 Invalid Password override.
151 Invalid TPM/TCM set option.
152 There was an error setting the TPM/TCM option.
153 There is no setup password installed on this system.
154 The setup password supplied is incorrect. Please try again.
155 Profile should be custom for setting cpupowermode, memorypowermode and
fanmode.
156 There was an error setting the Power Option.
157 The power cap value entered is out of range. Please try again.
158 The power cap value entered must be between 0 to 100 if unit is percent.
159 Invalid IPv6 address. The IPv6 address cannot be link-local or multicast.
160 Invalid IPv6 address. The IPv6 address specified has incorrect address
format.
161 Invalid IPv6 address. The gateway address specified has incorrect address
format.
162 Invalid IPv6 address. The Primary DNS server address specified has incorrect
address format.
Messages And Codes 229