CLI Guide

MemPatrolScrub
Table 200. MemPatrolScrub
Valid Arguments
• On systems prior to Dell’s 12th generation PowerEdge systems: NA
• On Dell’s 12th generation PowerEdge and later systems: Standard, Extended,
Disabled
Description
Sets the Memory Patrol Scrub frequency as Standard Mode, Extended Mode, or
Disabled.
Example:
A:>syscfg --MemPatrolScrub=Standard
MemPatrolScrub=Standard
Applicable Systems Dell’s 12th generation PowerEdge and later systems
MemRefreshRate
Table 201. MemRefreshRate
Valid Arguments
• On systems prior to Dell’s 12th generation PowerEdge systems: NA
• On Dell’s 12th generation PowerEdge and later systems: 1x, 2x
Description
Sets the Memory Refresh Rate as 1x or 2x
Example:
A:>syscfg --MemRefreshRate=1x
MemRefreshRate=1x
Applicable Systems Dell’s 12th generation PowerEdge and later systems
MemVolt
Table 202. MemVolt
Valid Arguments
• On systems prior to Dell’s 12th generation PowerEdge systems: NA
• On Dell’s 12th generation PowerEdge and later systems: AutoVolt, Volt15V, Volt135V
NOTE: Volt15V represents 1.5 Volt and Volt135V represents 1.35 Volts.
Description
Sets the DIMM voltage selection.
Example:
A:>syscfg --MemVolt=AutoVolt
MemVolt=AutoVolt
Applicable Systems Dell’s 12th generation PowerEdge and later systems
MonitorMwait
Table 203. MonitorMwait
Valid Arguments
• On systems prior to Dell’s 12th generation PowerEdge systems: NA
• On Dell’s 12th generation PowerEdge and later systems: Enabled, Disabled
Description
Enables or disables Monitor/Mwait instructions. You can disable Monitor/Mwait only
when C state is disabled in Custom mode.
90