CLI Guide

7
Messages And Codes
This section documents the error messages and codes used in Dell OpenManage Deployment Toolkit (DTK).
SYSCFG Error Codes And Messages
The SYSCFG utility checks your commands for correct syntax and valid input. When you enter a command, a message is displayed
stating the results of the command.
Failure Messages
The SYSCFG utility failure messages provide error codes to help diagnose why some commands do not succeed. The following table
lists SYSCFG error codes and messages.
Table 371. SYSCFG Error Codes and Messages
Error Code Message
0 Success
1 Attempt to read write-only parameter.
2 Password cannot exceed 16 characters.
3 A BMC was either not detected or is not supported.
4 This username is already in use. Enter a unique username.
5 Access mode not supported.
6 Cannot return number of requested data bytes.
7 User ID 1 cannot be assigned a username.
8 Cannot execute duplicated request.
9 There was an error clearing the SEL.
10 Clear SEL cannot be accompanied with any other option.
11 racreset cannot be accompanied with any other option.
12 Cannot execute command. Command, or request parameter(s), not supported
in present state.
13 Command not supported on given channel.
14 The community string may only contain printable ASCII characters.
15 Destination unavailable. Cannot deliver request to selected destination.
16 Cannot execute command. Insufficient privilege level.
17 Command illegal for specified sensor or record type.
18 Invalid commstring value.
187