CLI Guide

Option Sub-option Valid Arguments Description
--destipaddr <ipaddress>
Sets the destination IP address or Fully Qualied
Domain Name (FQDN) for the alert destination
specied with the alertdest sub-option.
The destipaddr sub-option is dependent on
the
alertdest sub-option. If the alertdest
sub-option is not specied on the command line,
the rst alert destination (alertdest=1) is
set with this IP address or FQDN. This sub-
option can be replicated.
NOTE: FQDN is applicable only for
destipaddr option and is supported
only on PowerEdge 12G systems.
Example 1 (to set the destination IP address):
A:>syscfg lcp --alertdest=1 --
destipaddr=192.168.100.15
Example 2 (to set the destination IP address as
FQDN):
A:>syscfg lcp --alertdest=1 --
destipaddr=xxx.yyy.com
--alertdest 1, 2, 3, 4
Sets the destination for the LAN alert. This sub-
option can be replicated.
--vlantag enable,
disable
Enables or disables VLAN tagging. This sub-
option can be replicated.
--vlanid <string>
Sets the 12-bit VLAN ID. This sub-option can be
replicated.
--vlanpriority 0–7
Sets the VLAN priority value. This sub-option
can be replicated.
--macaddress
NA Displays the BMC MAC address. This sub-
option cannot be replicated.
--nicselection
NOTE: This option is
available only with the
appropriate installed license.
shared,
sharedfailove
r, dedicated,
sharedreceive
onall
Sets the operating mode of the NIC to shared,
sharedfailover, dedicated, or
sharedreceiveonall. Some of these
options are not applicable on certain systems.
NOTE:
This option is applicable on systems prior to
PowerEdge 12G systems. The
sharedreceiveonall argument is available
only on PowerEdge 11G systems.
--nicselection
NOTE: This option is
available only with the
appropriate installed license.
dedicated,
lom1, lom2,
lom3, lom4
Sets the operating mode of the iDRAC7 NIC to
dedicated, lom1, lom2, lom3, or lom4.
Some of these options are not applicable on
certain systems due to underlying hardware.
NOTE: This option is applicable on
PowerEdge 11G systems.
--nicselectionfailover
NOTE: This option is
available only with the
appropriate installed license.
none, lom1,
lom2, lom3,
lom4, all
Sets the operating mode of the NIC selection
failover to none, lom1, lom2, lom3, lom4, or
all. Some of these options are not applicable
on certain systems. due to underlying hardware.
126