CLI Guide

SYSCFG Options On PowerEdge Systems Prior To PowerEdge 12G Systems
The following are the valid options and arguments supported on PowerEdge systems earlier than PowerEdge 12G systems.
assignintr
Table 244. assignintr
Valid Arguments standard, distributed
Description Controls the interrupt assignment of PCI devices in the system. This option is set to
standard by default, causing standard interrupt routing that uses interrupt A, B, C, and
D for all PCIe devices. When set to distributed, the interrupt routing is swizzled at the
MCH root ports to minimize sharing of interrupts across all PCIe (and PCI-X in the
Programmable Interrupt Controller (PIC) mode) devices.
Example:
A:>syscfg --assignintr=standard
assignintr=standard
Applicable Systems All PowerEdge systems prior to PowerEdge 12G systems
bezelir
Table 245. bezelir
Valid Arguments enable, disable
Description Enables or disables the ESM to monitor and log front bezel intrusion conditions.
Example:
A:>syscfg --bezelir=enable
bezelir=enable
Applicable Systems All PowerEdge systems prior to PowerEdge 12G systems
cmosdefaults
Table 246. cmosdefaults
Valid Arguments enable, disable
Description
Enables or disables the request for a default CMOS value during the next reboot.
A:>syscfg --cmosdefaults=enable
cmosdefaults=enable
Applicable Systems All PowerEdge systems prior to PowerEdge 12G systems
conboot
Table 247. conboot
Valid Arguments enable, disable
Description
Enables or disables conguring or reporting of console redirection after reboot. This
option is available on all supported systems that support console redirection. This option
can be replicated.
Example:
A:>syscfg --conboot=enable
conboot=enable
Applicable Systems All PowerEdge systems prior to PowerEdge 12Gsystems
107