Release Notes

• OS deployment in AHCI non-raid mode
• OS deployment through HBA330 mini
• Support added for OS deployment on greater than 2TB (raid and non-raid in UEFI Mode)
• Support for OS deployment on SSD (SATA/SAS) harddisk
• Support added for OS deployment on harddisk connected to Rear backplane
• Added support for NvMe device
• Added support for PERC 10 controllers
• Support for the following network cards:
• NetXtreme BCM5719/5720 1Gbps devices
• NetXtreme-E BCM574xx 10Gbps/25Gbps devices
• Mellanox ConnectX-4 Dual Port 100 GbE QSFP Network Adapter
• QLogic 10GE BASE-T 2Port PCIe FH/LP
• QLogic 10GE SFP+ 2Port PCIe FH/LP
• QLogic 25GE SFP28 2Port PCIe FH/LP
• Intel X550 rNDC
• Intel 10GbE 4P X710
• Added support for the following Dell PowerEdge servers:
• R740
• R740XD
• R640
• R940
• C6420
• R7920
NOTE:
For the list of supported operating systems and Dell servers, see the Dell Systems Software Support Matrix at dell.com/
openmanagemanuals.
Important Notes
This product includes software developed by the OpenSSL Project for use in the OpenSSL Toolkit (http://www.openssl.org/).
Use both DTK and the Server Administrator from the same release version to get complete supported features of Server Administrator.
DTK operating system deployment limitation:
DTK does not support operating system deployment, when multiple boot VDs exist on a single controller or when the server has multiple
boot controllers. If multiple boot controllers exist on the server, the boot VD must be created on any one of the controllers, and the boot
VD must be set as first boot device in system BIOS.
On debranded or rebranded servers, Deployment toolkit is not supported.
DTK does not support Linux operating system deployment in Non RAID (Volume) and SWRAID mode on s140 controllers.
SYSCFG
• Some options may not be present on all systems, which may be due to the BIOS version or hardware feature set. The usage
information generated by running SYSCFG without arguments shows only those options that are valid for your system.
• The --devseq option is present only if you have an available, bootable hard-disk partition. If this option is present in the configuration
file, but not present on your system, you will receive a usage error.
• To enable certain options, to reboot your system. Dell recommends you use the "reboot" command on shell prompt or press the Ctrl
+Alt+Del keys.
• It is required to perform a warm reboot after applying the SYSCFG settings changes on Dell’s 12th generation of PowerEdge systems.
• If you perform operations that change the --redmem option, reboot your system immediately. It is applicable to both command line
and --infile usage.
NOTE:
Additionally, the --redmem option should not be issued with any other command and should be immediately followed
by a system reboot. This is important when you develop scripts that can alter the --redmem setting.
Dell EMC OpenManage Deployment Toolkit 6.0.1 for Embedded Linux Release Notes 3