CLI Guide

Table 371. SYSCFG Error Codes and Messages (continued)
Error Code Message
16 Cannot execute command. Insufficient privilege level.
17 Command illegal for specified sensor or record type.
18 Invalid commstring value.
19 Hardware subsystem error. Invalid data field in Request.
20 Invalid destination IP address.
21 The GUID is invalid.
22 Invalid gateway.
23 Invalid hostname.
24 Invalid IP address.
25 Invalid DNS IP address.
26 Invalid sub net mask.
27 Invalid value for PEF. PEF value should be between 1 and 16.
28 Reservation Canceled or Invalid Reservation ID.
29 Invalid Time to live value.
30 Invalid VLANID value.
31 Invalid Command. Used to indicate an unrecognized or unsupported
command.
32 Command invalid for given LUN.
33 Load defaults cannot be accompanied with any other option.
34 There was an error loading the defaults.
35 Node Busy. Command could not be processed because command processing
resources are temporarily unavailable.
36 Out of space. Command could not be completed because of a lack of
storage space required to execute the given command operation.
37 This parameter is not supported.
38 Parameter out of range. One or more parameters in the data field of the
Request are out of range.
39 The password may only contain printable ASCII characters.
40 Password test failed.
41 Requested data length invalid.
42 Requested data field length limit exceeded.
43 Requested Sensor, data, or record not present.
44 Request data truncated.
45 Command response could not be provided.
46 Command response could not be provided. BMC initialization or
initialization agent in progress.
47 Command response could not be provided. Device in firmware update mode.
48 Command response could not be provided. SDR Repository in update mode.
49 Cannot execute command, SEL erase in progress.
Messages And Codes 217